Connecting To A Pc - Panasonic HDC-SDX1 Operating Instructions Manual

With a PC
2
Setup
≥ Connect this unit to the PC after the software applications are installed.
≥ Remove the supplied CD-ROM from your PC.
A USB cable (supplied)
1
Connect this unit to the AC adaptor.
≥ It is possible to use it connected to the PC with the batteries only, but you will not be able to
write data into the unit.
≥ Connect with the AC adaptor when using the Conversion assist function.
2
Turn on the unit.
≥ This function is available in all modes.
3
Connect this unit to a PC.
≥ The USB function selection screen will appear.
4
Touch [PC] on the screen of this unit.
≥ The Smart wizard screen is automatically displayed when HD Writer AE 2.6X is installed.
≥ This unit is automatically recognised as an external drive of the PC. (l 105)
≥ When you select an option other than [PC], reconnect the USB cable.
≥ When using the battery, the LCD monitor turns off after about 5 seconds. Touch the screen
to turn the LCD monitor on.
≥ Do not use any other USB cables except the supplied one. (Operation is not guaranteed
with any other USB cables.)
≥ When the unit is connected to a PC it cannot be turned off.
Disconnect the USB cable, before turning this unit off.
≥ Do not disconnect the USB cable or the AC adaptor while the access lamp is on or card
access icon (
≥ When performing reading/writing between a PC and an SD card, be aware that some SD
card slots built into PCs and some SD card readers are not compatible with the SDHC
memory card or SDXC memory card.
≥ When using an SDXC Memory Card, check the following support site.
http://panasonic.net/avc/sdcard/information/SDXC.html

Connecting to a PC

) appears on the unit screen.

103
VQT2W75