8. Install a new solid-state drive into the storage converter. Then install the four screws to secure the
new solid-state drive to the storage converter.
Figure 64. Installing the new solid-state drive into the storage converter
9. To install the storage converter into the 3.5-inch hard-disk-drive bracket, flex the bracket and align pin
1
, pin
2
, pin
3
, and pin
Figure 65. Installing the storage converter with the new solid-state drive into the hard-disk-drive bracket
10. Install the storage converter with the bracket into the hard-disk-drive bay. See "Replacing the primary
hard disk drive" on page 91 or "Replacing the secondary hard disk drive" on page 92.
11. Connect the signal cable and the power cable to the solid-state drive.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
90
ThinkStation P310 User Guide
4
on the bracket with the corresponding holes in the storage converter.