Step 6: Verify Drive Operation; Configuration Considerations - Allen-Bradley PowerFlex 753 Quick Start Manual

Step 6: Verify Drive Operation

Now that you have completed the steps required to start up your drive for the first time, verify and record that each of your
drive/motor combinations is operating correctly.
Use the information displayed on the HIM, the drive status indicators to the right of the HIM, and the system operation to
assist with verifying drive operation.
1. Is each drive/motor combination responding correctly to each of the signal sources?
Signal Command Drive/Motor 1 Drive/Motor 2 Drive/Motor 3 Drive/Motor 4 Drive/Motor 5
Start
Stop
Direction (if applicable)
2. Is each drive/motor combination responding correctly to the speed reference source? (Check only those that apply.)
Speed Reference
HIM Source
Control Board Analog Input
Expansion I/O Module Analog
Input (Port 4)
Communications over
EtherNet/IP (Port 6 or Port 13)
Communications over Other
Protocol (Port 6)

Configuration Considerations

If any of your drive/motor combinations are not functioning properly, review steps 1...6 to be sure that the correct
information was gathered or calculated and that parameters were set correctly.
If your EtherNet/IP communications are not functioning properly, verify the controller/PLC is communicating the
expected commands and/or reference. For more information, refer to the PowerFlex 20-750-ENETR Dual-Port EtherNet/
IP Option Module User Manual, publication
Adapter User Manual, publication 750COM-UM001, or contact your PLC expert.
To interpret the Drive Status
If performance problems persist, refer to the publications listed in
If you feel you need additional technical support, gather the information listed on
representative.
Drive/Motor 1 Drive/Motor 2
Yes No Yes
Yes No Yes
Yes No Yes
Yes No Yes
Yes No Yes
750COM-UM008
Indicators, see page 65.
Rockwell Automation Publication 750-QS001A-EN-P - March 2015
Drive/Motor 3
No Yes No
No Yes No
No Yes No
No Yes No
No Yes No
or the PowerFlex 755 Drive Embedded EtherNet/IP
For More Information on page
page 83
Step 6: Verify Drive Operation
Drive/Motor 4 Drive/Motor 5
Yes No Yes
Yes No Yes
Yes No Yes
Yes No Yes
Yes No Yes
6.
prior to contacting a support
No
No
No
No
No
19