TEFAL IH2018 User Manual page 13

• When you press boil mode, the light above the button is
switched on and a beep sounds confirmation. The LCD
shows a "chaser".
• Select the B1, B2 or B3 level depending on the quantity of
water to heat up; the default level is B1.
• To adjust the setting, press on the + or - button; each
time you press the button a beep will be emitted to
confirm the change.
B1 (small) 16cm pan
~ 0,4 litres – 0,9 litres
• When the water reaches 100° C, the appliance emits 3 beeps
and stops heating.
• If you want to cancel boil mode, you can select another
program or press the on/off button.
• The timer function is not available for this mode.
Timer function for all functions except
boiling water and heating milk
• After defining the setting, press the timer (L) button and
• Press +/- button to set the cooking time ( 1-99min).
• For stew , after 60 min, the LCD shows « 1 H » and « 2 H »
• After 3 seconds without any action the Timer starts and
• At any time you can change the setting for Manual and Fry
• If you press a second time on the Timer button ,the LCD
• When timer goes below 1 min, the timer counts down in
• To remove the Timer function, press the Timer button for
B2 (medium) 18cm pan
~ 1 litre – 1,5 litres
the LCD shows a default time ( 15 min). A beep sounds and
the timer setting starts blinking with a default time of 15 min.
for 1 and 2 hours
LCD stops blinking.
programs with +/- button.
starts blinking again and you can change setting with +/-.
seconds until it reaches to « 00 » then the Hob switches off
and the beep sounds 3 times.
3 seconds.
B3 (large) 20cm pan
~ 2 litres – 2,5 litres
EN
13