Tension Adjustment Of The Door Spring; Connection Of Drain Hoses - Baumatic BAD4504 Instruction Manual

Tension adjustment of the door spring

●
The door springs are set at the factory to the proper tension for the outer door. If aesthetic
wooden panel are installed, you will have to adjust the door spring tension. Rotate the adjusting
screw to drive the adjustor to strain or relax the steel cable(see figure 5).
Adjust the door spring
tension until the door
remains balance in the
fully-opened position.
【Figure5】
Tension adjustment
of the door spring

Connection of drain hoses

●
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it
run into the sink, making sure to avoid bending or crimping it. Use the speical
plastic support that comes with the appliance (figure 6).The top of the hose must be at
a height between 40 and 100cm. The free end of the hose must not be immersed in
water to avoid the back flow of it. ATTENTION: The special plastic hose support must be
solidly fastened to the wall to prevent the drain hose from moving and allowing water
to spill outside the drain.
【Figure6】
Drain pipe connection
DISHWASHER
Inlet pipe connector Drain pipe connector
FRONT VIEW
SINK
P O W E R O U T L E T
Min 100mm
rel ax
16