Protection Systems; Alarms; Warnings; Emission Information - Generac Power Systems 6055 Owner's Manual

General Information
2.3 — Protection Systems
The owner/operator is alerted to Alarm and/or Warning conditions via the control pad LCD screen. All Alarm conditions
cause the generator to shut down. The Warning messages alert the operator to conditions that do not disable the unit,
require immediate correction, or result in shut down.
Some of the possible Alarm/Warning messages are listed below.
NOTE: For Synergy specific alarms, see Subsection 5.3 — Synergy Troubleshooting.
2.3.1— Alarms
High Temperature
Low Oil Pressure
Overcrank
Overspeed
2.3.2— Warnings
Charger Warning
Charger Missing AC
Low Battery
The above list is not all inclusive. For more information about alarms, see Section 5 Troubleshooting.
NOTE: A WARNING alerts the operator to a condition that must be addressed, but does not shut down the gen-
erator. An ALARM shuts down the generator to protect the unit from damage. In the event of an alarm, the
owner may clear the alarm and restart the generator. If the alarm occurs again, contact your independent ser-
vicing dealer.
2.4 — Emission Information
The U.S. Environmental Protection Agency (EPA) requires that this generator comply with exhaust emission standards.
This generator is certified to meet the applicable EPA emission levels, and is certified for use as a stationary engine for
standby power generation. Any other use may be a violation of federal and/or local laws. To ensure that the engine
complies with applicable emission standards for the duration of its service life, it is important to perform the mainte-
nance tasks described in Subsection 4.3 — Service Maintenance Schedule. This generator is certified to operate on
Liquid Propane Vapor fuel or pipeline Natural Gas.
The Emission Control System code is EM (Engine Modification). The Emission Control System on this generator may
consist of the following components:
Air Induction System
– Intake Pipe / Manifold
– Air Cleaner
Fuel Metering System
– Carburetor / Mixer
Assembly
– Fuel Regulator
8
Underspeed
RPM Sensor Loss
Wiring Error
Overvoltage
Exercise Set Error
USB Warning
Download Failure
Ignition System
– Spark Plug
– Ignition Module
Exhaust System
– Exhaust Manifold
– Muffler
Synergy Automatic Standby Generator Owner's Manual
Undervoltage
Fuse Problem
Overload
Stepper Overcurrent