Copy Character Set From Rom To Ram; Cancel User-Defined Character; Select Or Cancel Emphasized Mode - CognitiveTPG A798 Programming Manual

Revision D 10/13

Copy character set from ROM to RAM

ASCII
ESC : 0 0 0
Hexadecimal
1B 3A 30 30 30
Decimal 27 58 0 0 0
Default:
Current active ROM code page
Copies characters in the active ROM set to RAM. Use this command to re-initialize the user-defined character set. Code
page 437 is copied by default at initialization.
This command is ignored if current font is the user font.
Related information
To modify characters in one of the character set variations, such as rotated print, select one of the rotated print commands,
copy to RAM, then use the define user-defined character set command (1B 26).

Cancel user-defined character

ASCII ESC ? n
Hexadecimal
1B 3F n
Decimal
27 63 n
Value of n: Specified character code.
Range of n:
32–255
Cancels the pattern defined for the character code specified by n. After the user-defined character is canceled, the
corresponding pattern from current active ROM code page is printed.
Exceptions
This command is ignored if n is out of range or if the user-defined character is not defined.

Select or cancel emphasized mode

ASCII
ESC E n
Hexadecimal
1B 45 n
Decimal 27 69 n
Value of n:
0 (bit 0) not selected
1 (bit 0) selected
(When 0 and 1 are the least
significant bit, LSB)
Range of n:
0-255
Default: 0 (Off )
Starts or stops emphasized printing. The printer is reset to the standard print mode after a clear printer (0x10) command is
received.
Exceptions
Only the lowest bit of n is effective. Emphasized printing cannot be used with bit-images or downloaded bit-images.
Related information
This command and the select print mode(s) command (1B 21) function identically. They should have the same setting
when used together.
In A793 emulation, this command is unrecognized and the parameter byte is put into the print buffer.
Chapter 4: Programming Commands
A798-PG00001D
53