Select Cut Mode And Cut Paper; Print Test Form; Print And Paper Feed; Print And Feed Paper One Line - CognitiveTPG A798 Programming Manual

38 Chapter 4: Programming Commands

Select cut mode and cut paper

ASCII
GS V m
Hexadecimal
1D 56 m
Decimal 29 86 m
Value of m:
Selects the mode as shown in the table.
Value of n: Determines cutting position only if m is 65 or 66.
m Feed and cut mode
0, 48 Full cut (no extra feed)
1, 49 Partial cut (no extra feed)
65 Feeds paper to cutting position + (n times vertical motion unit), and cuts the paper completely
66 Feeds paper to cutting position + (n times vertical motion unit), and performs a partial cut
Range of m: 0, 48; 1, 49
65, 66 (when used with n)
Range of n:
0 – 255
Default of m, n: 0
Selects a mode for cutting paper and cuts the paper. There are two formats for this command, one requiring one parameter
m, the other requiring two parameters m and n. The format is indicated by the parameter m.
Formulas
n times the vertical motion unit is used to determine the cutting position to which the paper is fed.

Print test form

ASCII
US t
Hexadecimal 1F 74
Decimal 31 116
Prints the current printer configuration settings on the receipt.
Disabled in page mode.

Print and paper feed

The print and feed commands control printing on the receipt and paper feed by the printer.

Print and feed paper one line

ASCII
LF
Hexadecimal
0A
Decimal 10
Prints one line from the buffer and feeds paper one line.
Carriage return/line feed pair prints and feeds only one line.
GS V m n
1D 56 m n
29 86 m n
A798-PG00001D
Revision D 10/13