Specifications - Stihl MS 362 Instruction Manual

Specifications

EPA / CEPA
The Emission Compliance Period
referred to on the Emissions
Compliance Label indicates the number
of operating hours for which the engine
has been shown to meet Federal
emission requirements.
Category
A = 300 hours
B = 125 hours
C = 50 hours
Engine
STIHL single cylinder two-stroke engine
MS 362
Displacement: 59.0 cc
Bore: 47 mm
Stroke: 34 mm
Engine power to 3.5 kW (4.7 bhp)
ISO 7293: at 9,500 rpm
Idle speed: 2,800 rpm
Max. permissible
speed (with cutting
attachment): 14,000 rpm
Ignition System
Electronic magneto ignition
Spark plug (resistor Bosch WSR 6 F,
type): NGK BPMR 7 A
Electrode gap: 0.5 mm
MS 362
This spark ignition system meets all
requirements of the Canadian
Interference-Causing Equipment
Regulations ICES-002.
Fuel System
All position diaphragm carburetor with
integral fuel pump
Fuel tank capacity: 600 cc (0.6 l)
Chain Lubrication
Fully automatic, speed-controlled oil
pump with rotary piston. Additional
manual oil flow control
Oil tank capacity: 325 cc (0.325 l)
Weight
dry, without bar and chain
MS 362:
Cutting Attachment
Actual cutting length may be less than
the specified length
STIHL cutting attachments complying
with CSA Standard Z 62.3:
Rollomatic guide bars
Bar lengths
(3/8" pitch): 40, 45, 50 cm
Groove width: 1.3 mm
3/8" chains
Rapid Micro (33 RM) Type 3650
Rapid Super (33 RS) Type 3623
Rapid Super 3 (33 RS3) Type 3624
Pitch:
Drive link gauge:
Chain Sprockets
7-tooth for 3/8" (rim sprocket)
7-tooth for 3/8" (spur sprocket)
Other cutting attachments
Other cutting attachments complying
with CSA Standard Z 62.3 are available:
see section CSA Standard Z 62.3, the
chain leaflet inside the chain box or
contact your local STIHL dealer.
Please ask your STIHL dealer to
properly match your powerhead with the
appropriate bar/chain combinations to
reduce the risk of kickback injury.
5.9 kg
English
3/8" (9.32 mm)
1.3 mm
47