Spark Arresting Screen In Muffler; Spark Plug - Stihl MS 362 Instruction Manual

Spark Arresting Screen in
Muffler
If engine performance deteriorates,
N
check the spark arresting screen in
the muffler
Let the muffler cool down
N
1
2
Unscrew the screw (1)
N
Pull out spark arresting screen (2)
N
Clean the dirty spark arresting
N
screen, replace if damaged or
heavily carbonized
Refit the spark arresting screen
N
Fit screw
N
MS 362

Spark Plug

If the engine is down on power,
N
difficult to start or runs poorly at idle
speed, first check the spark plug.
Fit a new spark plug after about 100
N
operating hours – or sooner if the
electrodes are badly eroded. Install
only suppressed spark plugs of the
type approved by STIHL – see
"Specifications".
Removing the Spark Plug
Move the Master Control lever to the
N
stop position (0).
Push the hand guard forward – the
N
chain is locked.
2
1
Open the twist locks (1) by turning
N
them 1/4 turn counterclockwise with
the combination wrench.
Remove the shroud (2).
N
Pull off the spark plug boot.
N
Unscrew the spark plug.
N
Checking the Spark Plug
1
Clean dirty spark plug.
N
Check electrode gap (A) and
N
readjust if necessary – see
"Specifications".
1
Rectify the problems which have
N
caused fouling of the spark plug.
Possible causes are:
Too much oil in fuel mix.
–
Dirty air filter.
–
Unfavorable running conditions.
–
English
A
37