Table of Contents
Advertisement
Chapter 2 Getting Started — Installing/removing the projector
2)
Adjust the orientation of the main unit.
f Rotate the shaft holder and adjust the ball joint movable part to the direction to tilt the main unit, and adjust
the orientation of the main unit.
Main unit
The shaft holder will rotate 360° when the ball
joint fixing screw is loosened.
Rotate the shaft holder and move the ball joint
movable part to the direction to tilt the main unit.
3)
Tighten the ball joint fixing screw.
f While supporting the main unit, securely tighten the ball joint fixing screw using the supplied 3/16" Allen
wrench.
Attention
f The main unit and the power supply unit are connected with cables, etc. Do not rotate or tilt the main unit more than necessary.
f When adjusting the orientation of the main unit while connected to an external device via connection cable, please be careful not to damage
the connection cable.
f Please store the ball joint stopper in an appropriate manner for future use.
Note
f After adjusted roughly, fine adjust the projection position while projecting.
f The ball joint fixing screw and the ball joint stopper are hexagonal socket head fixing screws (M6). Note that the ball joint stopper can be
removed if you need and the ball joint fixing screw will come off the projector if it is loosened too much.
Removing the projector from the track system
1)
Turn off the power of the track system.
WARNING
When removing the projector from the track system, be sure to turn off the power of the track system.
Electric shocks can result.
40 - ENGLISH
Shaft holder
360°
The ball joint will become free when the ball joint stopper is removed.
The main unit can be rotated 360° or the main unit can be tilted 90° at
the ball joint movable part.
Pole
Shaft holder
Ball joint fixing screw
Ball joint stopper
Ball joint movable part
Ball joint movable range:
Approximately 90°
360°
Advertisement
Table of Contents
