Specifications - Panasonic PT-JX200HBU Operating Instrucctions

Specifications

The specifications of the projector are as follows.
Model No.
Power supply
Power consumption
Size
DLP chip Display system
Number of pixels 786 432 pixels (1 024 x 768 dots)
Electric zoom
Lens
Electric focus
Light source
Light output
*3
Contrast ratio
*3
Projected image size
Screen aspect ratio
Projection method
Card slot
Outer case
Outer color
Weight
Noise level
*3
Temperature
Operating *5
environment
Humidity
Power supply
Operating range
Remote
control
Weight
Dimensions
*1 When the [SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [ECO], the network function (both wireless LAN and wired LAN)
cannot be used in standby mode.
*2 When the [SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [NETWORK], the network function while in standby mode is
restricted to the projector operations via wired LAN using the Wake on LAN function.
*3 Measurement, measuring conditions and method of notation all comply with ISO/IEC 21118:2012 international standards.
*4 Operations of the Panasonic SD memory card up to capacity of 2 GB and Panasonic SDHC memory card up to capacity of 32 GB are confirmed.
*5 The operating environment temperature should be between 0 °C (32 °F) and 35 °C (95 °F) when using the projector at elevations between 1 000 m
(3 281') and 2 700 m (8 858') above sea level.
When using the projector at elevations lower than 1 000 m (3 281') above sea level, and the operating environment temperature becomes 35 °C
(95 °F) or higher, the light output may be reduced to protect the projector. When using the projector at elevations between 1 000 m (3 281') and 2
700 m (8 858') above sea level, and the operating environment temperature becomes 30 °C (86 °F) or higher, the light output may be reduced to
protect the projector.
r Applicable scanning frequency/terminal/wireless LAN
Model No.
Applicable
scanning HDMI signal
frequency
*1
<HDMI IN>
terminal
<AUDIO OUT>
terminal
Terminal
<LAN> terminal
<DC OUT>
terminal
Chapter 7 Appendix — Specifications
120 V ~ (120 V alternating current), 50 Hz/60 Hz
240 W (2.3 A)
In standby mode (when [STANDBY MODE] is set to [ECO]): 0.4 W
In standby mode (when [STANDBY MODE] is set to [NETWORK]): 0.5 W
In standby mode (when [STANDBY MODE] is set to [NORMAL] and the fans are stopping): 12 W
14.0 mm (0.55") (aspect ratio 4:3)
1-unit DLP chip, DLP type
1.3 to 2.9:1
F = 2.0 to 2.7
f = 15.2 mm to 32.7 mm
Laser diode (Maximum output: 36 W x 2, Wavelength: 452 - 458 nm)
2 000 lm (ANSI)
1 000:1
0.76 m (30") to 5.08 m (200")
4:3
[FRONT]/[REAR]
(On/off of vertical flip can be set with [VERTICAL FLIP])
SD card slot x 1 (supports SDHC memory card)
*4
Molded plastic
PT-JX200HBU: Black, PT-JX200HWU: White
4.5 k] (9.92 lbs.)
When [LIGHT POWER] is set to [NORMAL]: 33 dB
When [LIGHT POWER] is set to [ECO]: 30 dB
0 °C (32 °F) to 40 °C (104 °F)
10 % to 80 % (no condensation)
DC 3 V (AAA/R03 or AAA/LR03 battery x 2)
Within approx. 7 m (22'11") (when operated directly in front of signal receiver)
63 ] (2.2 ozs.) (including batteries)
Width: 44 mm (1-23/32"), Height: 105 mm (4-1/8"), Depth: 20.5 mm (13/16")
525 (480) /60p, 525 (480) /60i, 625 (576) /50p, 625 (576) /50i, 750 (720) /60p, 750 (720) /50p,
1125 (1080) /60p, 1125 (1080) /60i, 1125 (1080) /50p, 1125 (1080) /50i
640 x 480/60, 800 x 600/56, 800 x 600/60, 1024 x 768/60, 1280 x 1024/60,
1280 x 720/50, 1280 x 720/60, 1280 x 768/50, 1280 x 768/60,
1280 x 800/50, 1280 x 800/60, 1600 x 900/50, 1600 x 900/60
1 set, HDMI 19 pins, HDCP compatible
Audio signal: Linear PCM (Sampling frequency: 48 kHz/44.1 kHz/32 kHz)
1 set, M3 stereo mini jack (monitor output, stereo compatible)
0 V [rms] to 2.0 V [rms] (variable), output impedance 2.2 kΩ or less
1 set, RJ-45, for network connection, PJLink compatible, 10Base-T/100Base-TX
USB connector (type A) x 1, for power supply (DC 5 V, maximum 2 A)
PT-JX200HBU/PT-JX200HWU
*1
PT-JX200HBU/PT-JX200HWU
*2
ENGLISH - 147