Communication Port - Hitachi CP-WU9100 User Manual

Command Control using the Network

Communication Port

The following two ports are assigned for the command control.
TCP #23
TCP #9715
Configure the following items from a web browser when command control is used.
Port Settings
Network Control
Port1 (Port: 23)
Network Control
Port2 (Port: 9715)
When the authentication setting is enabled, the following settings are required.
Security Settings
Network Control
16
Click the [Enable] checkbox to open [Network
Port open Control Port1 (Port: 23)] to use TCP #23.
Default setting is Enable
Click the [Enable] check box for the
[Authentication] setting when authentication
Authentication
is required.
Default setting is Disable.
Click the [Enable] check box to open [Network
Control Port2 (Port: 9715)] to use TCP
Port open
#9715.
Default setting is Enable.
Click the [Enable] check box for the
[Authentication] setting when authentication
Authentication
is required.
Default setting is Enable.
Authentication
Enter the required authentication password.
Password
Confirm this setting is the same for [Network
Control Port1 (Port: 23)] and [Network
Re-enter
Control Port2 (Port: 9715)].
Authentication
Default setting is blank.
Password