Advertisement
Command Control using the Network
When the projector connects to the network, the projector can be controlled with
RS-232C commands from the computer with web browser.
For details of RS-232C commands, refer to RS-232C Communication / Network
command table (&21).
NOTE • If data is transferred using wireless and wired LAN at the same time,
the projector may not be able to process the data correctly.
Connection
Turn off the projector and the computer.
1.
If you use wired LAN, connect the projector's LAN or HDBaseT
2.
computer's LAN or HDBaseT port with a LAN cable. Use the cable that fulfills
the specification shown in figure. If you use wireless LAN, insert the USB
wireless adapter into the WIRELESS port of the projector.
Turn the computer on, and turn the projector on after the computer has
3.
started up.
LAN or
HDBaseT port
・LAN cable (CAT-5e or greater)
・For HDBaseT connection
- CAT-5e or greater
- shielded type (connectors included)
- straight cable
- single cable
Command Control using the Network
WIRELESS port
LAN or HDBaseT port
or
TM
port to the
USB wireless adapter
15
Advertisement
