Table of Contents
Advertisement
10
Electrical Connections
1.10
Switch off the power to the control unit
while making connections.
Mount the control unit in a position where it
is not easily accessible to the user. The
enclosure is IP45 rated and may be
mounted in zone 2 of the bathroom.
Strip wires 10 mm and twist prior to
inserting into spring loaded contacts.
Push contact arm back with a finger or
small screwdriver before inserting wire and
then release.
Check for good connection using
gentle tug on wire.
1.
Connect pump supply wires to
Pump Red and Pump Black
connections.
2.
Connect flow sensor to sensor
connections using the colours as
indicated on the controller board.
For cold supply use FS1 and for hot
use FS2 connections - see diagram.
1.12
Advertisement
Table of Contents
