Maintenance every day
6.6 Clean the machine
Caution
!
Perform cleaning work only after the engine
has cooled down and with the engine stopped.
Fig. 40
Caution
!
Do not guide the water jet directly into the dry
air filter intake opening (Fig. 40) and into the
opening for the crank handle. Cover the elec-
tric equipment against the direct water jet.
After wet cleaning run the engine warm to
l
evaporate all water residues and to avoid cor-
rosion.
BPR 45/55 D, BPR 55/65 D
6.7
Check the engine oil level
Caution
!
Park the machine on level ground so that the
engine is in horizontal position.
For quality of oil refer to the "table of fuels and
lubricants".
Fig. 41
Shut down the engine.
l
Open the rear rubber cover.
l
Pull the dipstick (Fig. 41) out, wipe it off with a
l
lint-free, clean cloth and reinsert it until it bot-
toms.
Pull out the oil dipstick again and read the oil
l
level.
The oil level should reach the upper mark on
l
the dipstick. If the oil level is too low top up oil
immediately.
After a running time of approx. one minute
l
shut the engine down, wait until all oil has run
back into the oil sump, check the oil level.
BOMAG
Maintenance every day
43