Step 1 Speaker Setup - Panasonic SC-HT16 Operating Instructions Manual

1
Step
Speaker stands with long cables
Supplied
accessories
Front and surround speaker assembly
• To prevent damage or scratches, lay a soft cloth and perform assembly on it.
• For assembly, use a Phillips-head screwdriver.
1
Attach the pipe to the base.
1
Thread the speaker cable through the base.
• Untie the cable before threading.
2
Insert the pipe.
2
Attach the stand to the speaker.
Before attaching, check the speaker label.
SC-HT17
• SB-FS930: Use as front speakers. Attach the stands with the short cables.
• SB-FS880: Use as surround speakers. Attach the stands with the long cables.
You can also attach to the upper rear of the speaker.
Ensure the stand is fastened on straight by lightly tightening the top and bottom
screws alternately until fully tightened.
• There is no difference between the right and left speakers.
4
Speaker setup
(x 2)
SC-HT17
Match the holes.
Speaker stands
(x 2)
SC-HT17
SC-HT16 SC-HT15
3
Secure the pipe to the base.
Ensure the screws are securely fastened by lightly tightening
the left and right side screws alternately until fully tightened.
The supplied stands are specially designed for use with
this unit's speakers.
Only use as indicated in this setup.
Large screws
(included)
Stand bases
(x 4)
SC-HT17
(x 2)
SC-HT16 SC-HT15
Small screws
(included)
Speaker height
Front Speakers
Try to line up the middle of the
speakers with the middle of the
television.
Surround speakers
It is usually better to position the
surround speakers a little higher.
(x 2)