HP ProOne 400 G1 All-in-One Hardware Reference Manual page 38

8. Loosen the captive screw securing the hard drive cage in the chassis (1).
9. Slide the hard drive cage left, and then lift it out of the chassis (2).
Figure 2-32
10. Remove the four mounting screws (1) securing the 2.5-inch drive adapter in the hard drive cage.
Be sure to keep the screws together with the blue rubber grommets to use to install a
replacement drive.
11. Slide the 2.5-inch drive adapter out of the hard drive cage (2).
Figure 2-33
12. Remove the four screws (1) securing the 2.5-inch drive in the drive adapter. Be sure to keep the
screws to use to install a replacement drive.
32 Chapter 2 Hardware repair and upgrade
Removing the hard drive cage
Removing the drive cage