Advertisement
QuickSpecs
Overview
Optional P700m Smart Array Controller for direct attach and shared SAS storage external to the c-Class enclosures
Optional HP D2200sb PCIe Storage Blade for direct attached and shared storage within the c-Class enclosures
Internal Drive Support:
Internal Drive Support
Internal Drive Support
Internal Drive Support
Two (2) hot-plug small form factor (SFF) drive bays
Support for SAS, SATA, and SSD hot-plug hard drives
Network Controller:
Network Controller
Network Controller
Network Controller
Four (4) embedded HP NC553i 10Gb FlexFabric adapter ports supporting autosensing 10Gb/1Gb Ethernet, FCoE,
Flex-10, TCP/IP offload engine, hardware-based accelerated iSCSI, and iSCSI boot.
NOTE:
NOTE:
NOTE:
NOTE: Fibre Channel over Ethernet (FCoE) capability requires the use of an HP Virtual Connect FlexFabric 10Gb/24-
port Module or HP 10GbE Pass-Thru Module.
The embedded adapter ports are routed interconnect bays 1 and 2 (c7000) and interconnect bay 1 (c3000)
One (1) 10/100 network adapter port dedicated to iLO 3 Management
Mezzanine Support:
Mezzanine Support
Mezzanine Support
Mezzanine Support
Three (3) mezzanine expansion slots as follows:
Two (2) Type II (25 watts) x8 PCIe Gen2; mezzanine slots 2 and 3 supporting QDR IB, 4Gb and 8Gb FC, 10Gb
FlexFabric, 10Gb Flex10, 10GbE, 1GbE, I/O accelerator cards, the Smart Array RAID controllers, and the PCI
Pass-thru Expansion card.
Mezzanine slot's 2 ports are routed to interconnect bays 5,6,7,8 (c7000) and 3,4,3,4 (c3000)
Mezzanine slot's 3 ports are routed to interconnect bays 7,8,5,6 (c7000) and 3,4,3,4 (c3000)
One (1) Type I (15 watts) x4 PCIe Gen2; mezzanine slot 1 supporting 4Gb and 8Gb FC, 10Gb FlexFabric,
10Gb Flex10, 10GbE, 1GbE, and the I/O accelerator cards
Mezzanine slot's 1 ports are routed to interconnect bays 3,4,3,4 (c7000) and 2,2,2,2 (c3000)
NOTE:
NOTE: HP recommends 10Gb adapters be installed in a x8 PCIe slot for optimal performance.
NOTE:
NOTE:
NOTE:
NOTE: Type II slots accept both Type I or Type II cards. Type I slots accepted Type I cards only.
NOTE:
NOTE:
Expansion Blade Support
Expansion Blade Support
Expansion Blade Support
Expansion Blade Support:
Up to two HP BladeSystem Expansion Blades (Ultrium Tape Blades, PCI Expansion Blade, and Storage Expansion
Blade) are supported using the HP PCI Expansion Pass-thru mezzanine Card. One HP PCI Express Mezzanine Pass-Thru
Card is required per Expansion Blade.
NOTE: The PCI Express Mezzanine Pass-Thru Card(s) must be installed in mezzanine slots 2 and/or 3.
NOTE:
NOTE:
NOTE:
NOTE:
NOTE:
NOTE:
NOTE: In a c3000 rack enclosure where the blades are installed horizontally, up to two expansion blades may
installed in the two slots created by the mini divider in the top half of the enclosure with a BL620c G7 installed in the
lower half of the enclosure.
NOTE:
NOTE: In a c3000 tower and c7000 rack enclosure where the blades are installed vertically, two expansion blades
NOTE:
NOTE:
may installed in the blade slots adjacent to the BL620c G7 by staking one on top of another via a blade coupler that is
included with the PCI Express Mezzanine Pass-Thru Card and the expansion blades. If a single expansion blade is
installed, it must be installed in the lower slot adjacent to the BL620c G7; a half-height server may be installed above
the expansion blade.
Internal USB and SD Support:
Internal USB and SD Support
Internal USB and SD Support
Internal USB and SD Support
One (1) internal USB 2.0 connector for USB flash media drive keys
One (1) internal micro secure digital high capacity (SDHC) card slot
Trusted Platform Module (TPM)
Trusted Platform Module (TPM)
Trusted Platform Module (TPM)
Trusted Platform Module (TPM):
One (1) internal TPM 1.2 module connector
Infrastructure Management:
Infrastructure Management
Infrastructure Management
Infrastructure Management
This server blade requires the latest version of the Onboard Administrator firmware. This firmware release may also
require other subsystem firmware upgrades. For information on the latest firmware versions, please see the Blades
Firmware Maintenance website at:
compmatrix.html
HP Integrated Lights-Out 3 (iLO 3) management processor for simplified server setup, health monitoring and recovery,
power and thermal control, and lights-out remote administration.
HP Insight Control, a product option, delivers essential infrastructure management that can help save time and money
by making it easy to deploy, monitor, control and optimize your IT infrastructure through a single, simple management
console. Insight Control supports both Windows and Linux-based central management servers.
http://h18004.www1.hp.com/products/blades/components/c-class-
DA - 13747
Worldwide — Version 16 — September 26, 2011
HP ProLiant BL620c Generation 7 (G7) Server Blade
HP ProLiant BL620c Generation 7 (G7) Server Blade
HP ProLiant BL620c Generation 7 (G7) Server Blade
HP ProLiant BL620c Generation 7 (G7) Server Blade
Page 4
Advertisement
