Advertisement
1
Power button
2
Lens cap
Powering Off the Projector
DO NOT UNPLUG THE PROJECTOR BEFORE PROPERLY SHUTTING DOWN USING THE FOLLOWING STEPS.
1. Press the power button to turn off the projector. The "Power Off the Lamp?" message appears on the OSD.
2. Press the power button again. The cooling fans continue to operate for 2 minutes.
3. If the LAMP light is solid orange, replace the lamp.
4. If the TEMP light is solid orange, the projector has overheated. The display automatically shuts down. Try turning the display on again after the
projector cools down. If the problem persists,
5. If the TEMP light is blinking orange, a projector fan has failed and the projector will automatically shut down. If this problem persists,
6. Disconnect the power cord from the electrical outlet and the projector.
7. If you press the power button while the projector is running, the "Power Off the Lamp?" message appears on the screen. To clear the
message, press any button on the control panel or ignore the message; the message will disappear after 5 seconds.
Adjusting the Projected Image
Adjusting the Projector Height
To raise the projector:
1. Press the elevator button.
2. Raise the projector to the desired display angle, and then release the button to lock the elevator foot into position.
3. Use the tilt adjustment wheel to fine-tune the display angle.
To lower the projector:
1. Press the elevator button.
2. Lower the projector, and then release the button to lock the elevator foot into position.
Notice: To avoid damaging the projector, make sure that the elevator foot is fully retracted before placing the projector in its carrying case.
1
Elevator button
2
Elevator foot
3
Tilt adjustment wheel
Downloaded From projector-manual.com DELL Manuals
contact
Dell.
contact
Dell.
Advertisement
