Energetics pr 4910p e-z Assembly Manual page 9

Deck Lubrication
The walking belt has been pre-lubricated at the factory. However, it is recommended that the waking board be
checked periodically for lubrication to ensure optimal treadmill performance. Your treadmill should not have to be
lubricated usually within the first year or 500 hours of use.
Every 30 days or 20 hours of operation lift the sides of the walking belt and feel the top surface of the walking board
as far as you can reach. If there are signs of silicone, no further lubrication is required. If it feels dry to the touch, follow
the instructions below. Please use a non-petroleum based silicone.
To apply lubricant to the walking belt:
1. Position the walking belt so that the seam is located on top and in center of the walking board.
2. Insert the spray nozzle into the spray head of the lubricant can.
3. While lifting the side of the walking belt, position the spray nozzle between the walking belt and the board approx-
imately 6 cm from the front of the treadmill. Apply the silicone spray to the walking board, moving from the front of
treadmill to the rear. Repeat this on the other side of the belt. Spray approximately 4 seconds on each side.
4. Allow the silicone to "set" for 1 minute before using the treadmill.
Please keep children and pets away from the silicone oil at all times to prevent any swallowing of the substance.
EN
FR
RU
SL
HR
BS
SR
9