Attaching The Fan Blades - HAMPTON BAY Winfield Owner's Manual

Finishing the Fan
Installation
Tuck connections neatly into ceiling outlet
1.
box.
2. Slide the canopy up to mounting bracket and
place the key hole on the canopy over the
screw on the mounting bracket, turn canopy
until it locks in place at the narrow section of
the key holes. (Fig. 10)
Align the circular hole on canopy with the
3.
remaining hole on the mounting bracket,
secure by tightening the two set screws. Note:
Adjust the canopy screws as necessary until the
canopy and canopy cover are snug.
WARNING
MAKE SURE THE TAB ON THE HANGER
BRACKET PROPERLY SITS IN THE GROOVE
IN THE HANGER BALL BEFORE ATTACH-
ING THE CANOPY TO THE BRACKET BY
TURNING THE HOUSING UNTIL IT DROPS
INTO PLACE.
Screws

Attaching the Fan Blades

Attach blades to blade arms using three screws
1.
with fiber washers (Fig. 11). Start a screw into
the blade arm, do not tighten. Repeat for the 2
remaining screws and washers.
2. Tighten each screw securely starting with the
center screw. Make sure the blade is straight.
Repeat steps for the remaining blades.
3. Fasten blade assembly to motor using the
screws supplied. (Fig. 12)
Outlet Box
Blades
Ceiling
Mounting
Bracket
Canopy
Canopy
Bottom
Cover
Figure 10
WARNING
TO REDUCE THE RISK OF PERSONAL INJURY,
DO NOT BEND THE BLADES WHILE INSTALL-
ING, BALANCING THE BLADES, OR CLEANING
THE FAN. DO NO INSERT FOREIGN OBJECTS
BETWEEN ROTATING FAN BLADES.
Screws
Fiber Washers
Blade Arm
Figure 11
Screws
Figure 12
7