Makita DVC860L Instruction Manual page 7

Remaining battery capacity indication
Battery indicator status
Blinking
On Off
015527
Indicating the remaining battery capacity
(Only for battery cartridges with "B" at the end of the
model number.)
2
015676
Press the check button on the battery cartridge to
indicate the remaining battery capacity. The indicator
lamps light up for few seconds.
Indicator lamps
Lighted Off
015658
Remaining battery capacity
50% - 100%
20% - 50%
0% - 20%
Charge the battery
1. Indicator lamps
2. Check button
1
Remaining
capacity
Blinking
75% to 100%
50% to 75%
25% to 50%
0% to 25%
Charge the
battery.
The battery
may have
malfunctioned.
NOTE:
Depending on the conditions of use and the
•
ambient temperature, the indication may differ
slightly from the actual capacity.
Switch action
2
3
015529
To start the cleaner:
1. Set the stand-by switch to the "I" side. The
cleaner gets into stand-by state.
2. Press the power button.
To make the cleaner get into stand-by mode, press the
power button again.
To turn off the cleaner, set the stand-by switch to the "O"
side.
The suction power can be adjusted according to your
work need.
Suction power can be increased by turning the suction
force adjusting knob from the
symbol.
NOTICE:
Always set the stand-by switch to the "O" side
•
when not using the cleaner for long time. The
cleaner consumes power during stand-by state.
Auto-suction stop during wet suction
operation (for the cloth filter model)
WARNING:
Do not use for a long time while the float is at
•
work. Using the cleaner with its float at work for a
long time can cause overheat, resulting in the
cleaner deformation.
Do not pick up foam or soapy liquid. Picking up
•
foam or soapy liquid can cause foam to come out
of air exit before the float works. Continuing to
using in this condition may cause an electric shock
and breakage of the cleaner.
Auto-suction stop works only when using with the float
and float cage.
The cleaner has a float mechanism that prevents water
from immersing into the motor when picking up more
than a certain amount of water.
When the tank is full and the cleaner no longer picks up
water, switch off the cleaner and empty the tank.
7
1. Stand-by switch
2. Power button
3. Suction force
adjusting knob
1
symbol to the