Setting The Flash - HP Photosmart R507 User Manual

2
Press
until you reach the desired size in
the Image Display. A yellow frame
surrounds the area of the image
that will be captured. The
resolution
of the screen also becomes smaller
as you digitally zoom. For example,
place of 4MP, indicating that the image is being reduced to
a size of 3.2 Megapixels.
3
When the yellow frame is at the desired size, press the
Shutter
To turn digital zoom off and return to optical zoom, press
Out
Zoom Out
NOTE
your picture will tend to be more pixilated than the same
image taken with optical zoom. If you just intend to e-mail
an image or post it to a website, this loss of resolution will
not be noticeable, but in situations where the highest
quality counts (such as printing), limit the use of digital
zoom. It is also recommended to use a tripod when using
digital zoom.

Setting the Flash

NOTE
Burst
The Flash
the camera. To change the flash setting, press the
button until the desired setting appears in the Image Display.
The following table describes each of the flash settings on
the camera.
Downloaded From camera-usermanual.com HP Manuals
Chapter 2: Taking Pictures and Recording Video Clips
Zoom In again and hold it
number on the right side
button to take the picture.
on the Zoom lever
, and then press it again.
Digital zoom reduces the resolution of an image, so
The flash does not work in
setting, or while recording video clips.
button lets you cycle through the flash settings on
3.2MP
until digital zooming stops. Release
Panorama
appears in
Zoom
mode, with the
Flash
41