Set Up The Loudspeakers - Bang & Olufsen beolab 12 User Manual

4
We recommend that you follow
this procedure:
– Disconnect your system from the
mains supply.
– Place the loudspeakers according
to the guidelines in 'Connections
and settings', see page 6. For
information on how to fasten
the loudspeakers to the optional
accessory, refer to the guide
enclosed with the accessory.
– Set the switches to the correct
settings. This is explained in
'Connections and settings',
see pages 5–6.
– Connect your speaker system.
– Connect the entire system to the
mains supply again.

Set up the loudspeakers

Cautions
– Make sure that the loudspeakers
are placed and connected in
accordance with the instructions
in this Guide. To prevent injury,
use Bang & Olufsen approved
wall brackets only!
– The loudspeakers can only be
switched off completely by
disconnecting them from the
mains supply.
– Do not expose this equipment to
dripping or splashing and ensure
that no objects filled with liquids,
such as vases, are placed on the
equipment.
– No naked flame sources, such as
lighted candles should be placed
on the apparatus.
– The loudspeakers are intended
for indoor use in dry, domestic
environments only, and for use
within a temperature range of
10–40º C (50–105º F).
– Remember that all loudspeakers
in a setup must be connected to
a mains outlet, and that they are
designed to be connected to the
mains at all times, as this allows
them to switch on automatically.
– Do not attempt to open the loud-
speaker. Leave such operations to
qualified service personnel!
– The supplied mains cord and
plug are specially designed for
the product. If you change the
plug or damage the mains cord,
you must buy another from your
Bang & Olufsen retailer!
The product identification label is
placed on the rear part of the
loudspeaker.