Table of Contents
Advertisement
When you have finished setting
up the loudspeakers as described
on the following pages,
connect the entire system to
the mains supply. When in
standby, the indicator light is
switched off. The loudspeakers
are designed to be left in
standby mode when not in use.
NOTE! Prolonged listening at high
volume levels may cause hearing
damages.
Daily use
Switching on and off –
indicator light
When you switch on your Bang &
Olufsen system, the loudspeakers
switch on simultaneously. The
indicator light turns green,
indicating that the loudspeakers are
switched on. After some time, the
indicator light will fade down.
When you switch off your system,
the red indicator light appears
briefly, indicating that the
loudspeakers are not in use.
Loudspeaker protection
If an active speaker unit becomes
over heated, the affected
loudspeaker will instantly reduce
the sound level. Once the situation
has stabilised, the sound level is
slowly returned to normal.
If the indicator light is solid orange,
turn down the volume or allow
your loudspeakers to cool off.
If your loudspeakers detect a fault,
an orange indicator light will flash
until your loudspeakers are
disconnected from the mains supply.
Should the problem persist, contact
your Bang & Olufsen retailer.
Indicator
Cleaning the loudspeakers
Clean the loudspeaker surfaces
using a dry, soft cloth. If necessary,
remove stains or dirt with a soft,
damp cloth and a solution of water
and mild detergent such as
washing-up liquid.
The speaker cloth may be cleaned
with a vacuum cleaner with a
brush nozzle, and set to the lowest
suction level.
Never use alcohol or other solvents
to clean any part of the
loudspeakers!
3
Advertisement
Table of Contents
