Off Mode - CellSecure E12 CLEO User Manual

Numbers. Should the alarm not be switched off within this 1 minute buzzer time,
the siren will start to sound and the ALARM SMS messages will be sent to the
Base and cell numbers. An 'Alarm Activated' Telemetry signal will also be sent to
the Alarm Response Company if connected. At this time the alarm also switches
to Away mode.
Activating Stay mode:
• Stay mode can be activated by a key ring remote, SMS, or a keypad.
• To activate Stay mode by remote, the Yellow and Blue buttons must be
pressed simultaneously.
• To activate Stay mode by cellular phone or base station, $XXXXS must be
sent to the E12's control panel via SMS. In this message the XXXX is the
user four digit, numeric pin code the same as the user would use on the
keypad that can only be changed by the Master user.
• The system will respond as described above if activation was successful.
Deactivating Stay mode:
• Activate Off Mode. See section 1.1.3.
1.1.3. Off Mode: (Activated when at home)
• No zone is active when the E12 is in Off Mode.
• Selecting OFF Mode will result in different responses depending on the mode the
system was in before activating OFF mode.
• If the E12 was in Away Mode, the E12 will respond by sounding twice on the
internal siren, only if the system was not activated by a sensor while in Away
mode, and a system Off ("Disarmed") SMS message will be sent. An 'Alarm
disarmed' telemetry signal will also be sent.
• If the E12 was activated by a sensor while in Away mode, the system will
respond by sounding four times on the internal siren and a system Off
("Disarmed") SMS message will be sent. This is an additional warning function to
let the occupant know that the premises were entered.
• If the E12 was in panic mode with the siren sounding the siren will stop when Off
mode is activated.
• The messages are fully programmable, but the default message is "System OFF
Mode Group A/B". In the SMS the name of the person who disarmed the unit as
well as the address where the unit is located, will also be displayed.
• If "By system Timer" is displayed, the system was deactivated by the timer.
Activating Off Mode:
• Off Mode can be activated by key ring remote, a base station, a cellular
phone, keypad or timer.
• Press the yellow button on the key ring remote control once or send
$XXXXO to the E12 via SMS.
• To disarm the system by keypad, enter user code and press enter.
6