Table of Contents
Advertisement
Code #46: Setting friendly reception
FRIENDLY RCV
=ON
[±]
To receive a fax automatically when you answer
a call and hear a fax calling tone (slow beep).
"ON" (default): You do not have to press
{FAX/START} for fax reception.
"OFF": You have to press {FAX/START} for fax
reception.
Code #58: Setting the original mode
ORIGINAL
=NORMAL
[±]
To send or copy a document with faint or dark
writing, set this feature before starting
transmission or copying.
"NORMAL" (default): Used for normal writing.
"LIGHT": Used for faint writing.
"DARKER": Used for dark writing.
Code #68: Setting the Error Correction Mode
(ECM)
ECM SELECTION
=ON
[±]
This feature is available when the
transmitting/receiving fax machines are ECM
compatible.
"ON" (default): To send a fax even if there is static
interference on the telephone line.
"OFF": Deactivates this feature.
Note:
L You cannot change the setting when received
documents are in memory.
Code #76: Setting the connecting tone
CONNECTING TONE
=ON
[±]
If you often have trouble when sending faxes,
this feature allows you to hear connecting tones;
fax tone, ring back tone and busy tone. You can
use these tones to confirm the status of the other
party's machine.
"ON" (default): You will hear connecting tones.
"OFF": Deactivates this feature.
Note:
L If the ring back tone continues, the other
party's machine may not be a facsimile or
may have run out of paper. Check with the
other party.
L The connecting tone volume cannot be
adjusted.
7. Programmable Features
Code #80: Resetting advanced features to
their default settings
SET DEFAULT
RESET=NO
[±]
To reset the advanced features:
1. Press {MENU}.
2. Press {#}, then {8}{0}.
3. Press {A} or {B} repeatedly to select "YES".
4. Press {SET}.
5. Press {SET} again.
6. Press {MENU}.
Note:
L ECM selection (feature #68, page 37) will not
be reset.
37
Advertisement
Table of Contents
