Panasonic SA-AK110P Service Manual page 12

SA-AK110P /
disc tray. (Then, the CD will load.)
<The initial setting of CD unit is completed.>
8.3.2. Checking for the CD Servo P.C.B.,
Panel P.C.B., Deck P.C.B.,
Transformer P.C.B. and Power
P.C.B.
• Follow the (Step 1) - (Step 2) of Item 8.1.
• Follow the Disassembly for the CD Lid of Item 8.2.1.
• The initial setting of CD unit must be completed. (Refer to
the initial setting of CD unit in Item 8.3.1).
• Check for CD Servo P.C.B.
• The initial setting of CD unit must be completed. (Refer to
the initial setting of CD unit in item 8.3.1.)
Step 1 Push the power button and the power turns OFF.
Step 2 Remove the FFC boards.
Step 3 Remove the CD changer unit.
Step 4 Remove 4 screws.
Step 5 Remove the mechanism unit cover.
• Check the CD Servo P.C.B. as shown below
Step 6 Lay the unit.
Step 7 Connect the FFC board (19 pin) from CD servo P.C.B..
Step 1 Press the POWER button and the power turns off.
Step 2 Remove the connectors.
Step 3 Pull out the FFCs.
Step 4 Remove the CD changer unit.
Step 5 Lay the unit as shown below.
12