D-Link DIR-830L User Manual page 36

Section 3 - Configuration
Choose L2TP (Layer 2 Tunneling Protocol) if your Internet Service Provider (ISP) uses a L2TP connection. Your ISP will provide you with a username
and password.
L2TP Server IP Enter the L2TP server IP address provided by your ISP.
Address:
Username:
Enter the username provided by your ISP.
Password: Enter the password provided by your ISP.
Reconnect Mode: Select either Always-on, On-Demand, or Manual.
Maximum Idle Time:
Enter a maximum idle time during which the Internet connection
is maintained during inactivity. To disable this feature, enable Auto-
reconnect.
Address Mode: Select Static IP if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic IP.
L2TP IP Address: Enter the IP address provided by your ISP (Static IP only).
L2TP Subnet Mask: Enter the subnet mask provided by your ISP (Static IP only).
L2TP Gateway IP
Enter the gateway IP address provided by your ISP (Static IP only).
Address:
Primary DNS Server: Enter the primary DNS server IP address assigned by your ISP.
Secondary DNS
Enter the secondary DNS server IP address assigned by your ISP.
Server:
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
Click Save when you are done.
D-Link DIR-830L User Manual
L2TP
32