Installing Your Digital Receiver; Connecting Your Digital Receiver - Panasonic TU-HDT105A Operating Instructions Book Manual

4

Installing Your Digital Receiver

4.1

Connecting Your Digital Receiver

The following illustrations show some examples for connecting this HD Digital
Receiver. Select the connection that is best suited for your needs. Many other
connections may be possible when optional devices such as RF cable splitters are
included in your system. These devices may cause signal degradation and, if too
many are used, poor quality picture and sound may result.
Terrestrial antenna/cable connection
Connect the TV antenna cable to the HD Digital
Receiver RF IN connector. Also connect the
cable between your TV Antenna IN and RF Out
connector on the rear of the Digital Receiver.
This connection allows your TV set to receive
normal analogue programs. (Refer to A)
Video Connections
Adjust switch on the rear panel according to the format supported by your display
device, and it contains three modes: A, B and C.
Mode A (SD/HD, YPbPr)
Connect the YPbPr component video output
socket on your digital receiver to your display
device's YPbPr component video input. Be sure
to match the colours on the RCA sockets with t
coloured plugs. (Refer to B)
Note: When unit is in Mode A, there is no video
output from the CVBS TV socket.
Mode B (HD, RGB)
Connect the D-sub socket to your display
device. (Refer to C)
Note: Cable is not supplied.
Operating Instruction Book
(A) Aerial Connection
he
(B) YPbPr Connection
(C) RGB Connection
TU-HDT105A
7