Output Mode Selection - Panasonic TU-HDT105A Operating Instructions Book Manual

Output Mode Selection

4.2
After you have connected the AV cables for video and audio between your digital
receiver and the display device, check that the position of the output selection switch
is correct for your chosen connection method as in the table below.
Switch Position
Switch on the digital receiver and the display device, and select the correct AV input
on the display device. The digital receiver will take about 10 seconds to switch on.
You may now start the installation procedure.
The installation procedure is used to set up the video formats that may be output
from the digital receiver to the display device. During this procedure the digital
receiver may test if the display device is capable of correctly displaying 576i, 576p,
1152i, 1080i and 720p video formats. You will be asked to test these video formats
on the display device and confirm if the picture is displayed correctly. If the display
device is not capable of displaying a particular video format, the digital receiver will
return to the last correctly displayed format after about 12 seconds.
Note: In some cases, a display device will fail to return to a previously tested mode
after failing to display the next mode (i.e. the display does not support this format). If
you experience this, turn the display device off, wait 10 seconds and then turn the
display device on.
Installation Format Selection
Use the Remote Control keypad to perform the digital receiver format testing and
installation. Follow the digital receiver's on-screen instructions to do the installation.
Mode A (SD/HD, YPbPr)
The switch on the rear of the digital receiver
must be in position A, and the AV connections
must be taken from the YPbPr RCA sockets.
The digital receiver display will show "HdcI".
Press OK to confirm the selection, or switch to
another mode. Proceed to INSTALLATION.
Note: If the STB is connected to a HD only YPbPr input on the display, no picture will
be displayed until you have pressed the
Video Output Format
A YPbPr (Component Video)
B
C
RGB
CVBS / S-Video
TV/TEXT to change to 576p format.
Operating Instruction Book
TU-HDT105A
Receiver Mode
SD / HD
HD
SD
You have selected YPbPr format
at the rear panel switch.
Press OK to continue.
9