Specifications; Ec Declaration Of Conformity - Makita bhr240 Instruction Manual

ENGLISH
1-1. Red part
1-2. Button
1-3. Battery cartridge
2-1. Switch trigger
3-1. Reversing switch lever
4-1. Rotation with hammering
4-2. Lock button
4-3. Action mode changing knob
5-1. Rotation only
6-1. Hammering only
7-1. Grip base
7-2. Side grip

SPECIFICATIONS

Capacities
No load speed (min
Blows per minute
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Note: Specifications may differ from country to country.
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an
recycling facility.
Intended use
The tool is intended for hammer drilling and drilling in
brick, concrete and stone as well as for chiselling work.
It is also suitable for drilling without impact in wood,
metal, ceramic and plastic.
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 89 dB (A)
sound power level: 100 dB (A)
Explanation of general view
7-3. Loosen
7-4. Tighten
7-5. Teeth
7-6. Protrusion
8-1. Bit shank
8-2. Bit grease
9-1. Bit
9-2. Chuck cover
10-1. Bit
10-2. Chuck cover
11-1. Action mode changing knob
11-2. O symbol
Model
Concrete
Steel
Wood
-1
)
Overall length
Net weight
Rated voltage
equipment and
environmentally compatible
END001-1
Uncertainty: 3 dB(A)
The typical weighted root mean square acceleration
value is 9.5 m/s
These values have been obtained according to
EN60745.
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this
its product is in compliance with the following standards of
standardized documents;
EN60745,
Directives, 89/336/EEC, 98/37/EC.
ENE043-1
000087
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
ENG006-2
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan
4
13-1. Depth gauge
14-1. Dust cup
16-1. Blow-out bulb
18-1. Chuck adapter
18-2. Keyless drill chuck
19-1. Sleeve
19-2. Ring
20-1. Limit mark
21-1. Screwdriver
21-2. Brush holder cap
BHR240
18 mm
13 mm
26 mm
0 - 1,100
0 - 4,000
410 mm
3.0 kg
D.C. 18 V
Wear ear protection.
2
.
EN55014 in accordance
Yasuhiko Kanzaki CE2006
Director
ENH102-5
with Council