Setting The Clock - Siemens HB26D552W Instruction Manual

Changing the end time
The duration has elapsed
Cancelling the end time

Setting the clock

After a power cut
Changing the clock
Changing the clock display
The setting is applied. The appliance is in standby
position. The display shows the End time y. The
operation starts at the appropriate time. The Duration
counts down in the display.
This is possible provided the appliance is in standby.
Press the 0 button. Use the ¿ or ¾ button to switch
to the End time and correct the End time using the
rotary selector. Close the Time setting options using
the 0 button.
A signal sounds. The appliance stops heating. The
Duration is set to x 0:00. Press the 0 button to stop
the signal.
This is possible provided the appliance is in standby.
Press the 0 button. Use the ¿ or ¾ button to switch
to the End time. Turn the rotary selector anticlockwise
until the display goes out. The set Duration starts
counting down immediately.
To set the clock or change the time, the appliance
must be switched off.
After a power cut, "Set clock" will appear in the
display.
1. Set the current time using the rotary selector.
The set language does not change after a power cut.
2. Press the 0 button.
The time is applied.
Example: change the clock from summer time to
winter time.
1. Press the 0 button.
2. Use the ¿ button to switch to Clock 0 and
change the time using the rotary selector.
3. Close the Time setting options by pressing the
0 button.
When the appliance is switched off, the current time
appears in the display. You can change this display or
switch it off (see section: Basic settings).
23