Installing/Removing Modules; Installing A Module - Siemens RUGGEDCOM RX1511 Installation Manual

RUGGEDCOM RX1511
Installation Guide
Section 3.9

Installing/Removing Modules

The following sections describe how to install and remove modules:
• Section 3.9.1, "Installing a Module"
• Section 3.9.2, "Removing a Module"
Section 3.9.1

Installing a Module

Upon installing a new module in the device, all the features associated to the module are available in the
operating system. For more information, refer to the ROX II User Guide for the RX1511.
To install a module, do the following:
1. Make sure power to the device has been disconnected and wait approximately two minutes for any
remaining energy to dissipate.
2. If the device is installed in a rack, remove it from the rack.
3. Remove the current module from the slot. For more information, refer to
4. Insert the new module into the slot.
Figure 50: Installing a Module
1. Module 2. Chassis
5. Tighten the screws to secure the module.
6. If necessary, install the device in the rack.
7. Connect power to the device.
Installing/Removing Modules
3. Screw
Communication Ports
Section 3.9.2, "Removing a
1
2
3
Chapter 3
Module".
33