Description - Siemens RUGGEDCOM RX1511 Installation Manual

Chapter 1
Introduction
Section 1.2

Description

The RX1511 features various ports, controls and indicator LEDs on the front panel for connecting, configuring and
troubleshooting the device.
Figure 1: RUGGEDCOM RX1511
1. Utility USB Port 2. RS232 Serial Console Port (RJ45)
5. Alarm Indicator LED
• Management Port – This 10/100Base-T Ethernet port is used for system management that is out-of-band from
the switch fabric.
• RS-232 Serial Console Port – The serial console port is for interfacing directly with the device and accessing
initial management functions. For information about connecting to the device via the serial console port, refer to
Section 2.5, "Connecting to the
• Utility USB Port – Use the USB port to upgrade the ROX II software or install files, such as configuration
files and feature key files. For more information, refer to the RUGGEDCOM ROX II User Guide for the
RUGGEDCOM RX1511.
• Lamp Test/Alarm Cut-Off (LT/ACO) Button – This button performs two functions:
▪ Press and hold this button to test all indicator LEDs
▪ Press and release this button to acknowledge an active alarm
• Power Status LEDs – Indicate the status of the power modules.
▪ Green = Power is on
▪ Off = Power is off
• Port Status LEDs – Indicate when ports are active.
▪ Green = OK
▪ Orange = Warning alert
▪ Red = Configuration error
2
1
2
3
4
6. Port Status LEDs 7. Management Port
Device".
5 6
7
3. Lamp Test/Alarm Cut-Off (LT/ACO) Button
RUGGEDCOM RX1511
Installation Guide
4. Compact Flash Card Port
Description