Restore Dvd - Tormach pathpilot Technical Document

3. With the PathPilot controller powered on, click Update on the Status screen (see Figure 3).
4. Navigate to the (vX.X) file on the USB drive and click Update (see Figure 4).
Figure 3
5. Push red E-stop in when prompted and click OK.
6. To receive email notifications when new versions of PathPilot are released, click Subscribe to receive
PathPilot news & updates on www.tormach.com/updates.

Restore DVD

A restoration DVD is included with each controller. This DVD is used to restore the PathPilot controller to the
original factory settings.
CAUTION! Data Loss: The DVD restore process completely erases the existing operating system and all
files on the hard drive. Before installing, save important files to a USB drive or external hard drive. Failure to
do so will result in total data loss.
To install, load into the Optical Drive (#3), and restart the controller. Click OK to all screen prompts. The
process takes approximately 10 minutes.
Tormach Inc.
1071 Uniek Drive, Waunakee, WI 53597
Phone: 608.849.8381 / Fax: 209.885.4534
Figure 4
Specifications subject to change without notice.
Page 6
©Tormach® 2014. All rights reserved.
TD10358_PathPilot_Controller_QSG_0216A