Solectek skyway User Manual page 49

radius_server RW 10.20.20.3
radius_timer RW
radius_user RW wpa1@host.loc
reboot W
rfnetname RW NAME_1
rmod RW
route R
rssi R
savecfg W
serialnum R
set R
show R
snmp RW enabled
public – for all
strings
192.168.1.1 for
trap manager
status R
streams RW
sysmode RW retains
sysmode
tz RW "+00:00"
set radius_server [server_ipaddr]
show radius_server
86400 set radius_timer [period]
show radius_timer
set radius_user [name]
al show radius_user
reboot
set rfnetname [netname]
show rfnetname
set rmod [macaddr] [streams] [bpsk-1/2 |
qpsk-1/2 | qpsk-3/4 | qam16-1/2 | qam16-
3/4 | qam64-2/3 | qam64-3/4| AUTO]
show route
show rssi
savecfg
show serialnum
set ?
show
set snmp enable=[yes|no]
set snmp [read-community|rc]=[abcdef]
set snmp [trap-community|tc]=[abcdef]
set snmp [trap-manager|tm]=[a.b.c.d]
show snmp
status
1 show streams
set streams [1 | 2]
show sysmode
set sysmode [MULTIPOINT_MASTER |
MULTIPOINT_SLAVE]
tz [+hh:mm | -hh:mm]
Base Station only. Sets Radius
Server IP address
Base Station only
Set Radius reauthentication period,
in Seconds
Client Unit only
Set Radius client user name
Reboot system
Set RF Network Name
Set Remote Modulation/Streams
on
Show IP route table
Show Local Recv Signal Strength
Save configuration to permanent
memory
Show system serial number
Set ? for commands
Show commands
Set SNMP configuration
parameters
Show system status
Show / Set the number of MIMO
data streams. Limited to 1 for
Access 50.
Show / Set the MULTIPOINT
operating mode
Set/Show time zone
49