Solectek skyway User Manual page 24

There are several noteworthy items:
Software Version The currently installed, operating image version.
Up Time The elapsed time that the unit has been running since the last reboot or power cycle.
Ethernet Port – details of the Ethernet port status can be viewed by clicking the details on the right
side of the screen. The actual screen is shown in Section C below. The Ethernet Port MAC address is
shown for diagnostics purposes, but has no effect on the base station to client wireless connection.
RF Port – The RF Port MAC address is what is used by access control and thus must be entered into
the access control list at the base station.
RF Port Link State The link state has two values.
Green – An RF link has been established
Red – An RF link is NOT established.
Client MAC – This section indicates the basic status of each client unit associated with the base
station. If a client unit is connected (State light having turned green), you can click on the line to
see the details of the connection status as seen in the following screen:
RF Info – This section shows from values seen from base station (local) and client unit (remote).
The Base Station column shows the Tx power and modulation of the base station transmitter section
and RSSI experienced by the base station receiver section. Similar for the Client side column.
24