Motorola AP 7161 Installation Manual page 29

Installation Guide
6. With the Access Point positioned so that the gore vent is facing down, insert the two M6 hex flange
screws in the bottom holes on the sides of the Access Point bracket section into the open slot connections
on the bottom of the angle adapter bracket section.
7. Rotate the Access Point bracket section upward and align the top holes on the sides with the top holes
on the angle adapter bracket section. Insert two M6 hex flange screws into the top holes on the angle
adapter bracket section.
8. Use a torque wrench or a ratchet and a 10mm socket, or an adjustable wrench, to finish attaching the
Access Point bracket section to the angle adapter bracket section with the M6 hex flange screws in the
open slot connections and the top holes on the angle adapter bracket section. Do not tighten the screws
until all rotation and tilt adjustments are complete.
9. To adjust the position of the Access Point, rotate the Access Point bracket section (plus or minus 15
degrees) and tilt the angle adapter bracket section (up to 45 degrees).
10. Tighten all hex flange screws to 60 inch pounds (lbf-in).
29