Table of Contents
Advertisement
2.5.3
Removing the backplane
DO NOT remove the backplane unless necessary!
1.
Remove all hot-swap HDD trays from
the chassis.
2.
Disconnect all cables from the SATA/
SAS backplane.
3.
Loosen the four screws on the
backplane.
4.
Firmly hold the backplane, and turn it in
the direction of the arrow.
5.
Remove the backplane from the
module.
2.5.4
Installing a hot-swap SATA/SAS hard disk drive
1.
Release a drive tray by pushing the
spring lock to the right, and then pulling
the tray lever outward. The drive tray
ejects slightly after you pull out the lever.
ASUS TS300-E9-PS4
2-15
Advertisement
Table of Contents
