SamTimer User Manual page 5

www.SamTimer.com 1-888-SamTimer sam@samtimer.com
9
8
How to Start, Stop, Set, and Reset
3. If you selected user modes 5 to 8 or 9 to 12, you will
see two mode identifiers, one on the left display and
one on the right display of the clock . Press the center
red button to see two more mode identifiers . Press
the red button again to return to the first two modes .
With the mode identifiers on the display you may
press either play switch to select a mode. The
starting times for the mode will appear, and you are
ready to play . If later you want another mode, short
press the center button three times after resetting
the mode to return to the mode identifier display.
All modes and mode identifiers are listed on page
18. The modes are described in the section
Discussion of the Modes.
To summarize: if you selected user modes 5 to 8 or
9 to 12, just short press the center red button , if
necessary, to get the mode identifier for the mode
you want on the display, then press either the right
or left play switch to start the mode. Thus, after
turning on the clock, you only need to press a play
switch, or the center button and a play switch, to
select any user mode 5 to 12.
4. If you selected All modes, you may short press the
center red button repeatedly to cycle through all the
modes and mode identifiers of the clock . You may
long press the red button to go backwards if you
went past the mode you want. Press the left or right
play switch to select a mode . The factory
programmed starting time for that mode will appear.
You may change this time and copy it to a user mode
- see Set New Starting Times - Illustration on p 10
and How to Program 'the User Modes on p 16.
Short press the center button three times to get back
to the display of mode identifiers.
" Start the clock In all modes:,Press either play switch.
II
Stop the clock
In all modes: Press the center button .
(Press a play switch to start the clock again .)
Reset the
clock
For modes with the quick reset feature (see
feature E, p 22): Press the center button
once to stop the dock. Press the center
button again to reset it.
In all other modes: Press the center button to
stop the clock. Short press the center button
four more times to reset the clock . (This
makes it hard to accidentally reset the clock.)
Set new
starting time
In all modes: Put the mode in the starting
position or in the reset position . Long press
the center button to enter set mode . Short
press the center button until the digit you
want to change is flashing . Press the play
switch on either side until the number you
want for that digit appears on the display .
Short press the center button to change to
the next digit. If you short press the center
button enough times you will come back to
the first digit. \
\
Long press the center button at any time to
exit set mode . You are now ready to start the
clock . "
The next section illustrates this procedure.
For modes having feature F (see p 22)
In additi on to se tting the starting times, you may also alter the time
of a ga me in progress . Press the center button on ce to stop the
clock. Long pres s the center button . The first dig it will start to flash .
Follow th e procedure above . NOTE: with this procedure yo u may
only ch ange the current display time , not any other tim e control.