Displaying And Maintaining Qos Policies - HP 5920 Configuration Manual

protocol group type to identify the type of packets sent to the control plane. You can reference
protocol types or protocol group types in if-match commands in traffic class view for traffic
classification and then re-configure traffic behaviors for these traffic classes as required. You can
use the display qos policy control-plane pre-defined command to display them.
• If a QoS policy applied to the control plane uses if-match control-plane protocol-group or if-match
control-plane protocol for traffic classification in a class, the action in the associated traffic behavior
can only be car or the combination of car and accounting packet, and only the cir keyword in the
car action can be applied normally.
Configuration procedure
To apply the QoS policy to the control plane:
Step
1. Enter system view.
2. Enter control plane view.
3. Apply the QoS policy to
the control plane.

Displaying and maintaining QoS policies

Execute display commands in any view and reset commands in user view.
Task
Display traffic class configuration.
Display traffic behavior configuration.
Display QoS and ACL resource usage.
Display user-defined QoS policy
configuration.
Display QoS policy configuration on the
specified or all interfaces.
Display information about QoS policies
applied to VLANs.
Display information about QoS policies
applied globally.
Display information about QoS policies
applied to a control plane.
Display information about the pre-defined
QoS policy applied to the control plane.
Clear the statistics of the QoS policy
applied in a certain direction of a VLAN.
Command
system-view
control-plane slot slot-number
qos apply policy policy-name inbound
Command
display traffic classifier user-defined [ classifier-name ]
display traffic behavior user-defined [ behavior-name ]
display qos-acl resource [ slot slot-number ]
display qos policy user-defined [ policy-name [ classifier
classifier-name ] ]
display qos policy interface [ interface-type interface-number ]
[ inbound | outbound ]
display qos vlan-policy { name policy-name | vlan vlan-id } [ slot
slot-number ] [ inbound | outbound ]
display qos policy global [ slot slot-number ] [ inbound |
outbound ]
display qos policy control-plane slot slot-number [ inbound |
outbound ]
display qos policy control-plane pre-defined [ slot slot-number ]
reset qos vlan-policy [ vlan vlan-id ] [ inbound | outbound ]
22
Remarks
N/A
N/A
By default, no QoS policy
is applied to a control
plane.