Panasonic AW-E860L Operating Instructions Manual page 19

$ Connection of a remote control box (RCB)
The RCB (WV-CB700A) and the camera must be connected
with the optional RCB cable AW-CA50T10.
1. Turn RCB power off before connecting cables.
2. Connect the 50-pin connector of the RCB cable to I/F
REMOTE connector of the camera. The 10-pin connector
must be connected to the RCB.
3. Turn RCB power on and the camera can be controlled
remotely by the RCB.
RCB cable AW-CA50T10 (3 m)
DC cable with ø6.5 plug
supplied with AW-PS505A
AC adapter AW-PS505A
Notes:
• The monitor output signals of the RCB attenuate and
deteriorate with cable length. It is recommended that the
signals from the monitor output be used for monitoring
purposes only.
• No gen-lock signal is available from the RCB.
• If a longer distance (more than 3 m) is desired between the
camera and the RCB, use the following optional cable.
AW-CA50B10 and WV-CA10B02 (2 m)
Video signal IN
MONITOR OUT
- 18 (E) -
WV-CA10B25 (25 m)
WV-CA10B50 (50 m)
RCB
RCB WV-CB700A