AnyTone AT-289G Instruction Manual page 36

PROGRAMMING SOFTWARE LNSTALLING & STARTING (TAKES WINDOWS XP AS AN EXAMPLE)
1. Double-click "QPS289 SETUP.EXE", and then install the
software as per computer instructions.
2. Click "START" menu, select and click "USB TO COM PORT"
in the "QPS289" program from "ALL PROGRAM".
3. Connect the optional cable PC13 to the USB port in PC
device and connect the transceiver with the other end of
cable.
4. Double click "QPS289" setup short-cut icon or click "START"
menu to choose QPS289 entry in the QPS289 program from
"ALL PROGRAMS" menu (Refer to picture 1).
5. As per computer command, choose serial port "COM Port"
firstly (Refer to picture2), then click OK to start programming
software.
TIPS:
In one individual computer, users need to choose different
COM Port number when USB cable is connected with different
USB port.
To program frequency, power on the transceiver firstly. Do
not power on/off the transceiver when it is connected with
computer. Otherwise, the transceiver can not read or write
frequency well. If this condition happens, please firstly close
the programming software, disconnect USB Connector(PC13)
from computer, then, connect the USB connector with
28
Professional
FM Transceiver
(picture 1)
(picture 2)