Table of Contents
Advertisement
GROUNDING
IMPORTAN~
(Please read carefulIy)
FOR PERSONAL
SAFETW,
THIS APPLIANCE
MUST
BE PROPERLY
GROUNDED.
The power cord of this appliance is equipped with a
three-prong (grounding) plug which mates with a
standard three-prong grounding wall receptacle to
minimize the possibility of electric shock hazard from
this appliance.
The customer should have the wall receptacle and
circuit checked by a qualified electrician to make
sure the receptacle is properly grounded.
Insure proper ground
and firm connection
before use.
Where a standard two-prong wall receptacle is
encountered, it is the personal responsibility and
obligation of the customer to have it replaced with a
properly grounded three-prong wall receptacle.
DO NOT, UNDER ANY CIRCUMSTANCES,
CUT OR REMOVE THE THIRD (GROUND)
PRONG
FROM
THE POWER
CORD.
USAGE SITUATIONS
WHERE THE APPLIANCE
POWER CORD WILL BE DISCONNECTED
INFREQUENTLY.
For 15 amp circuit only, do not use an adaptor on a
20 amp circuit. Where local codes permit, a
TEMPORARY CONNECTION may be made to a
properly grounded two-prong wall receptacle by the
use of a UL listed adaptor available at most
hardware stores. The larger slot in the adaptor
must be aligned with the large slot in the wall
receptacle to provide proper ~olarity in the
connection of the power cord.
Insure proper ground
o~
and firm connection
lo
before use.
I
~r...
/
~%h
o
/
Align large
prongs/slots
v
!/
Temporary method
/d
,/1
@daptor plugs not
permitted in Canada)
UNLESS THE SCREW IS MIXAL, AND NOT
INSULATED, AND THE WALL RECEPTACLE IS
GROUNDED THROUGH THE HOUSE WIRING. THE
CUSlX3MER SHOULD HAVE THE CIRCUIT
CHECKED BY A QUALIFIED ELECTRICIAN 'IX3
MAKE SURE THE RECEPTACLE IS PROPERLY
GROUNDED.
When disconnecting the power cord from the
adaptor, always hold the adaptor with one hand. If
this is not done the adaptor ground terminal is very
likely to break with repeated use. Should this
happen, DO NOT USE the appliance until a proper
ground has again been established,
USAGE SITUATIONS
WHERE APPLIANCE
POWER
CORD WILL BE DISCONNECTED
FREQUENTLY.
Do not use an adaptor plug in these situations
because disconnection of the power cord places
undue strain on the adaptor and leads to eventual
failure of the adaptor ground
terminal.
The
customer should have the two-prong wall receptacle
replaced with a three-prong (grounding) receptacle
by a qualified electrician before using the appliance.
In Canada, mobile home installation must be in
accordance with the current CAN/CSA Z240/MH
Mobile Home Installation Code.
STEP 5: INSTALLING UNIT IN A STANDARD OR
TILE COUNTER
Before installing the unit in the cutout, attach the
adhesive backed foam tape (shipped with unit)
around the bottom surface of the glass, near the
edge of the maintop.
To attach the unit to the counter, insert the hold
down brackets in the slots on each side of the unit.
Use the screws supplied to attach unit to counter as
shown, The unit must rest on the metal flange
around the burner box and not on the glass.
MOUNTING
BURNER BOX
HOLD
DOWN
BRACKET \
Q
o
lb
Q
1
Q
Q
1
9
T
@".; =USE
SUITABLE
[}
Q ,~,,.."
FASTENERS FOR
\(p
t
"
o
ANCHORING
IN
/
9
CABINET
SIDES
CABINET
*
CAUTION:
A~ACHING
THE ADAPTOR GROUND
TERMINAL TO THE WALL RECEI?I''ACLE COVER
SCREW DOES NOT GROUND THE APPLIANCE
SIDES
6
Advertisement
Table of Contents
