Advertisement
2.1.3
Example of 3D Multiple Display Setup
The following instructions is an example of a multiple display setup or refer to Figure 2-3 Example of 3D
Multiple Display Setup.
1. Setup the warp and blends for the projector.
2. If necessary, shift or scale your image to fit the display.
3. Set all projectors to the largest minimum Frame Delay value that the worst case projector in the array can
achieve.
4. Enable 3D mode on all projectors. Using the remote >Main Menu>Image Settings>Advanced Image
Settings>3D Settings
5. Set all projectors 3D Sync Output to "Next Projector" with the exception of the last projector; select "To
Emitter."
6. Connect the PC emitter sync to either Input A (or B) on the 3D dongle.
7. Connect the output from the 3D dongle in the first projector to Input A (or B) on the next projector in the
array.
8. Repeat the same procedure to all projectors except the last projector in the array. Route the Sync output
from the 3D dongle to the emitter.
9. If your emitter has a reverse setting ensure it is set to the Off position.
10. Set all projectors to 3D Sync Input A (or B) depending on your selection in Step 6 & 7.
11. Apply the 3D test pattern to all projectors.
12. Put on your 3D glasses.
13. When 3D is setup correctly, a small set of the letter L is visble by closing your right eye and a small set of
the letter R is visible when closing your left eye.
14. If necessary, adjust the dark interval settings until the test pattern sees the least amount of ghosting for each
projector.
15. Adjust the 3D Sync Delay on the last projector in your array to match the optimal sampling point for the
glasses being used. NOTE: The default auto setup value is typically good for all glasses.
16. Turn off the 3D test pattern on each projector. Your 3D content should look optimal.
Mirage J Series User Manual
020-100708-01 Rev. 1 (11-2011)
Downloaded From projector-manual.com Christie Manuals
For the last projector, route the sync input.
NOTE:
Section 3: Operation
2-7
Advertisement
