HP M8502 Installation And User Manual page 58

Troubleshooting
Table 6-2. Fault Symptom Codes
Message
SCSI FIFO Error
SCSI Gross Error
Illegal SCSI Cnt Cmd
SCSI Invalid Element
SCSI Invalid Int.
Loader Not Ready
Door Open (status
only)
Cart Inaccessible
Drive In Error
No Magazine
Removal Prevented
Ctl. Firmware Error
Drive Time-out Error
Drive Code Update
Command Error
Move Command
Failure
Open Mail Slot Fault
Open Left Door Fault
Open Right Door Fault
M8501 and M8502 ACL Tape Drive Installation and User's Guide —529972-003
FSC ERP
1003 D, G
1004 C, D, G
1005 C, D, G
1007 D, G
1009 D, G
2004 C, G
2009 F
200C F
200D C, G
200E F
200F F
2010 C, G
2030 C, G
2080 C, G
2081 C, G
2090 C, G
2091 C, G
2092 C, G
6 -4
Fault Symptom Codes (FSCs)
The SCSI controller data FIFO should be
empty but still contains data bytes.
The SCSI controller detected a gross
error condition - invalid SCSI bus phase
or DMA error.
Either an invalid command was sent to
the SCSI controller, or the controller was
not in the correct mode.
Internal SCSI task processing error -
invalid element type was detected.
The SCSI controller posted an invalid
interrupt status.
Fail to fetch, stow, scan, move passthru,
Or when loader detects invalid command,
aborts command.
Door is force opened or door sensor
failed.
For an LTO, indicates the tape is not
ejected. Cartridge in drive is not
accessible from changer.
A general drive error detected by control
task.
Cannot move, element not installed, from
changer.
Receive medium prevent removal from
drive for a fetch.
Internal inter task processing error.
Unexpected event. SMX send or receive
error.
Cannot communicate with DLT drive.
Update code from SCSI or from TAPE
failed.
Move command from / to drive slot failed,
detected by control task.
Door open sensor time-out detected when
open door.
Door open sensor time-out detected when
open door.
Door open sensor time-out detected when
open door.