Table of Contents
Advertisement
C) DUST COMPARTMENT OPERATION
This bagless vacuum cleaner collects the dust in a dust
compartment located on the front of the cleaner.
Located within the dust compartment are the pre-filter and the pre-
filter wiper. The pre-filter wiper rotates around the pre-filter wiping
dust off towards the main dust compartment. It also helps to remove
large particles of dust that may get trapped on the pre-filter while
cleaning.
Located on the outside of the dust compartment is the Maximum
dust level mark. When the level of dust inside the dust compartment
nears the Maximum dust level, empty the dust compartment (see
page 9).
Always ensure that the dust compartment is emptied before the dust
reaches the Maximum dust level mark.
NOTE: The pre-filter wiper rotation may stop depending on the suction level.
D) ON / OFF SWITCH AND VARIABLE POWER CONTROL
The sliding lever - located on the control panel - is used to switch the
vacuum cleaner ON/OFF and vary the motor speed depending on the
suction required.
NOTE: Model MC-E590 without Variable power control.
Mod.: MC-E590
To switch ON, slide the button sideways to the "I" position.
To switch OFF, slide the button backward to the "O" position.
Mod.: MC-E591
To switch ON, slide the lever sideways to the "MIN" position. By sliding
the lever further sideways the power will gradually be increased.
Mod.: MC-E593
To switch ON, slide the lever sideways to the "AUTO" position. By sli-
ding the lever, the vacuum cleaner power will change in the following
sequence: AUTO - MIN - MAX.
To switch OFF, slide the lever backward to the "0" position.
AUTO
On the AUTO position,
the motor power will vary
automatically depending on
the dirt detected by the dust
sensor. Only for MC-E593
model.
NOTE: The pre-filter wiper rotation may stop depending on the suction level.
MIN
On the MIN position, the vacuum cleaner
works at minimum power, to clean
curtains and soft furnishings etc.,
with tool attached.
NOTE: When using tools, press the
beater bar pedal to the OFF position.
– 6 –
Pre-filter wiper
Pre-filter
Maximum dust
level mark
Sliding
lever
MAX
On the MAX position, the
vacuum cleaner works at
maximum power continuously.
This is used when maximum
suction is required.
Advertisement
Table of Contents
