Table of Contents
Advertisement
HOW TO ASSEMBLE / OPERATE YOUR CLEANER
A) HANDLE ASSEMBLY
Handle screw
1) Remove the dusting brush from
the handle and line the handle up
with the body of the cleaner in the
correct position as shown in the
illustration.
NOTE: Remove the handle screw
from the body first.
B) POWER CORD RELEASE / STORAGE
MC-E590
Upper
Cord hook
Lower
Cord hook
1) To store the power
supply cord, turn the
upper cord hook in to the
upright position and wind
the power supply cord
around the upper and
lower cord hooks.
NOTE: To avoid any possible damage to the power supply cord,
never run over the cord or allow it to become caught in the beater bar.
Dusting brush
2) Insert the base of the handle into
the top of the body of the cleaner
as shown. Push in the handle and
tighten the screw.
IMPORTANT: Do not over tighten
the screw.
2) To release the power
supply cord for instant
use, turn the upper cord
hook. Then fix the
power supply cord into
the cord clip to help
secure it during use.
– 5 –
3) Re-install the dusting brush
in its storage position.
Place the hose around the
hose clip and push inwards
to secure.
NOTE: Always place the hose
in a clockwise direction.
MC-E591 / MC-593
3) To release the power
supply cord, pull it out by
hand and fix it onto the
cord clip in order to help
secure it during use.
NOTE: When in use it is
advisable to pull out the
full length of the power
supply cord.
Hose clip
4) To rewind the power
supply cord, press and
hold the rewind button,
allowing the power
supply cord to be
automatically rewound
into the cleaner.
IMPORTANT: When
rewinding the power
supply cord, keep the
cord/plug in one hand
to avoid damaging the
cleaner.
Advertisement
Table of Contents
